All solutions

  • Carpet installation

    Make sure that you have all necessary tools and protective gear on hand before you begin: a large adhesive comb (4–6 mm between the teeth) to apply adhesive to larger surfaces and a small one (2 mm between the teeth) to apply adhesive to corners and hard-to-reach surfaces, a roller to even out bumps, and knee pads to ensure smooth progress of the work and reduce muscle fatigue while working.A suitable adhesive for installing carpeting is Penosil Premium Floor&Wall UniversalFix 619, which is also suitable for underfloor heating.Clean the surface with a vacuum cleaner.Mix the adhesive well before using it.Pour or apply adhesive to the surface and use an adhesive comb, if necessary. Do not use more adhesive than is necessary for installing carpeting.Move in the direction of your exit to avoid later applying adhesive while standing on carpeting.Apply adhesive evenly across the full width of the room, working in sections. Do not forget to apply adhesive to edges, corners and curved surfaces as well.Then, install pre-measured and pre-cut carpeting.Place carpeting on the floor with pre-applied adhesive and make sure that carpeting runs evenly along walls.Carefully smooth out carpeting to remove air bubbles and ensure that adhesive is in good contact with it. For best results, use a specially designed roller to install carpeting. Make sure that the full surface of the carpeting is in good contact with adhesive.When installing carpeting consisting of several sheets, press edges firmly together and use a roller. This helps to hide carpet seams and adds to their durability.Start with the next floor section, following the above steps.Repeat these steps until carpeting is installed on the entire floor.


We aim to create better products which last longer and provide quality service, therefor we look forward to your questions, opinions and proposals.

Please fill in all required fields.
Thank you for your feedback!